LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) - 2.4L >> DTC P0564 Cruise Control Multi-Function Input "A" Circuit >> Component Inspection

Component Inspection

  1. Ignition "OFF"
  2. Measure cruise remocon switch resistance as follows. (Component side)

    SPECIFICATION 

    TERMINAL RESISTANCE SPECIFICATION

    Terminal Condition Resistance
    1 & 2 Pushing the Main SW 3.9 kΩ ± 5%
    1 & 3 Pushing the Cancel SW 0Ω
    Pushing the Set/Coast SW 220Ω ± 5%
    Pushing the Resume/Accel SW 910Ω ± 5%
  3. Is resistance within the specification?

    YES 

    • Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

    • Substitute with a known-good cruise remote control switch and check for proper operation. If the problem is corrected, replace cruise remote control switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals