Control Circuit Inspection
- IG "OFF".
- Disconnect fuel pump relay and ECM/PCM harness connector.
- IG "ON".
- Measure the resistance between terminal 5 of A/C relay harness connector and terminal 37/C01-2 of ECM/PCM harness connector. (AT)
Measure the resistance between terminal 5 of A/C relay harness connector and terminal 46/C01 of ECM/PCM harness connector. (MT)
Specification: below 1Ω
- Is the measured resistance within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair Open in fuel pump control circuit and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.