Signal Circuit Inspection
- IG "OFF".
- Disconnect Fuel Level Sensor connector.
- IG "ON".
- Measure the voltage between terminal 3 of Fuel Level Sensor harness connector and ground.
Specification: Approx. 11 V
- Is the measured voltage within specification ?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair Short to ground circuit and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- In case of 0V, repair Open in signal circuit and then go to "VERIFICATION OF VEHICLE REPAIR " procedure. In case of 12V, repair Short to power in signal circuit and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.