Component Replacement After Deployment
NOTE:
Before doing any SRS repairs, use the Hi-Scan Pro to check for DTCs. Refer to the DIAGNOSTIC TROUBLE CODES (DTC)
list for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
- SRSCM
- Deployed airbag(s)
- Seat belt pretensioner(s)
- Front impact sensors
- SRS wiring harnesses
- Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the seat belt pretensioner(s) deployed after a collision, replace the following items.
- Seat belt pretensioner(s)
- SRSCM (if B 1658 detected)
- Front impact sensors
- SRS wiring harnesses
When the side/curtain airbag(s) deployed after a collision, replace the following items.
- SRSCM
- Deployed airbag(s)
- Side impact sensor(s) for the deployed side(s)
- SRS wiring harnesses
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
- Turn the ignition switch ON, the SRS indicator should come on for about 6 seconds and then go off.