Rear Hub / Carrier: Installation

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

Installation is the reverse of removal.
CAUTION:
- The rear hub lock nut should be replaced with new ones.
- After installation lock nut, stake the lock nut using a chisel and hammer as shown in the illustration below.
Fig 1: Staking Driveshaft Lock Nut
Courtesy of KIA MOTORS AMERICA, INC.

Fig 2: Identifying Driveshaft Lock Nut
Courtesy of KIA MOTORS AMERICA, INC.
Check the rear hub & bearing assembly starting torque using a spring balance.
Starting torque: 1.9 N.m (20 kgf.cm, 1.45 lb-ft)

Fig 3: Checking Rear Hub & Bearing Assembly Starting Torque
Courtesy of KIA MOTORS AMERICA, INC.