LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2007 >> Magentis 2.7 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Door Lock) >> Entry Lock And Unlock Switch >> Installation

Entry Lock And Unlock Switch: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 350 and 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FRONT DOOR OUTSIDE HANDLE SUBASSEMBLY 
    1. Insert the front end of the front door outside handle sub-assembly in to the front door out side handle frame.
    2. Insert the rear end of the front door outside handle assembly into the front door outside handle frame. Next slide the front door outside handle assembly to the front of the vehicle to install it.
      Fig 1: Inserting Front End Of Front Door Outside Handle Sub-Assembly
      G04049970Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using a "torx" socket wrench (T30), install the front door outside handle sub-assembly with the screw.
    4. Connect the connector.
  2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER (See  REASSEMBLY  ) 
  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY (See  REASSEMBLY  ) 
  4. INSTALL FRONT DOOR SERVICE HOLE COVER (See  REASSEMBLY  ) 
  5. INSTALL FRONT DOOR TRIM COVER (See  REASSEMBLY  ) 
  6. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY (See  REASSEMBLY  ) 
  7. INSTALL COURTESY LIGHT ASSEMBLY (See  REASSEMBLY  ) 
  8. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (See  REASSEMBLY  ) 
    Fig 2: Door Outside Handle Subassembly, Connector And Screw
    G04051374Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG (See  REASSEMBLY  ) 
scientia non olet · About LEMON Manuals