Signal Circuit Inspection
- Ignition "ON" & Engine "OFF".
- Disconnect the "OUTPUT SPEED SENSOR" connector.
- Measure voltage between terminal "2" of the OUTPUT SPEED SENSOR harness connector and chassis ground.
Specification: approx. 5V
- Is voltage within specification?
YES : --> Go to "POWER SUPPLY CIRCUIT INSPECTION " procedure.
no : --> Check for open or short in harness. Repair as necessary and Go to "VERIFICATION OF VEHICLE REPAIR " procedure
--> If signal circuit in harness is OK, Go to 2 "Check TCM (PCM)" of the "Component Inspection" procedure.