LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2006 >> Rio Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (SRS Control System) >> Side Impact Sensor (Sis) >> Removal >> Front Side Impact Sensor

Front Side Impact Sensor

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Removal of the airbag must be performed according to the precautions/procedures described previously.
  • Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).
  • Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
  1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
  2. Remove the door scuff trim. (Refer to INTERIOR TRIM )
  3. Remove the center pillar trim. (Refer to INTERIOR TRIM )
  4. Disconnect the Side Impact Sensor connector.
  5. Remove the SIS mounting bolt then remove the Side Impact Sensor.
    Fig 1: Locating Front Side Impact Sensor
    G04883722Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals