Rear Side Impact Sensor

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

Be sure that the battery negative cable is disconnected.
Install the new Side Impact Sensor with the bolt then connect the SRS harness connector to the Side Impact Sensor.
Tightening torque

: 1.0-1.4 kgf.m (9.5-13.6 N.m, 7.0-10.0 lb.ft)

Fig 1: Locating Rear Side Impact Sensor
Courtesy of KIA MOTORS AMERICA, INC.
Install the rear pillar trim. (Refer to INTERIOR TRIM )
Reconnect the battery negative cable.
After installing the Side Impact Sensor, confirm proper system operation: Turn the ignition switch ON, the SRS indicator light should be turned on for about six seconds and then go off.