Wheel Alignment: Toe: [Front]
WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
Toe-in (B-A or angle a+b) is adjusted by turning the tie rod turnbuckles. Toe-in on the left front wheel can be reduced by turning the tie rod toward the rear of the car. Toe - in change is adjusted by turning the tie rods for the right and left heels simultaneously at the same amount as follows.
Standard value:
Toe-in (B-A) mm (in): 0 ± 2 (0 ± 0.0787)
NOTE:
- Toe-in adjustment should be made by turning the right and left tie rods at the same amount.
- When adjusting toe-in, loosen the outer bellows clip to prevent twisting the bellows.
- After the adjustment, tighten the tie rod end lock nuts firmly and reinstall the bellows clip.
- Adjust each toe-in to be the range of ± 1mm.
Tie rod (A) Specified torque N.m (kgf.m, lb-ft): 70-80 (7-8, 50.6-57.8)