Engine Coolant Pump: Installation
- Clean the gasket mating surface of the water pump body and cylinder block.
- After installing new O-ring in the groove at front of the water pipe, soak it with water. At this time, do not soak it with oil or grease.
- After installing a new water pump gasket and water pump assembly, tighten it to the specified torque.
Tightening torque:
(A) 5EA: 14.7-21.6 N.m
(150-220 kg. cm, 10.8-15.9 lb. ft)
(B) 1EA: 32.4-49.0 N.m
(330-500 kg. cm, 23.9-36.2 lb. ft)
(C) 2EA: 19.6-26.5 N.m
(200-270 kg. cm, 14.5-19.5 lb. ft)
- Install the timing belt tensioner and timing belt. After adjusting the timing belt tension, install the timing belt cover.
- After installing the water pump pulley and driving belt, adjust the belt tension.
- Refill it with cooling water.
- Check the leakage by running the engine.