LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2002 >> Sedona LX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0560: Battery Backup Line Open >> Test Procedure

Test Procedure

  1. Turn ignition off. Disconnect ECM harness connector "B". Turn ignition on. Measure voltage between ground and ECM harness connector terminal B18 (White/Red wire). See Figure . Voltage should be battery voltage. If voltage is as specified, check for poor, loose, damaged and corroded terminals at ECM. Repair if necessary and go to step  3 . If voltage is not as specified, go to next step.
  2. Turn ignition off. Check P/TRAIN fuse (15 amp) in engine compartment fuse/relay box. If P/TRAIN fuse condition is okay, check circuit between ECM connector terminal B18 (White/Red wire) and battery voltage supply (Black wire). See WIRING DIAGRAMS article. if circuit is faulty, repair as necessary and go to step  4 . If circuit is okay, go to next step. If P/TRAIN fuse is blown, repair short circuit between battery voltage supply(Black wire) and ECM connector terminal B18 (White/Red wire). Repair as necessary, replace P/TRAIN fuse (15 amp) and go to step  4 .
  3. Temporarily install a known-good ECM and check for proper operation. If problem is corrected, replace ECM and go to next step.
  4. After repair, return vehicle to original condition. Clear codes using Hi-Scan Pro/Kia Data Pro Scan tool or equivalent. Verify repairs by driving vehicle and monitoring for pending codes. If DTC is set during test drive, follow appropriate DTC test procedure.
scientia non olet · About LEMON Manuals