Removal, Disassembly, Inspection, Reassembly, Installation: Reassembly
- When installing the steering ignition lock and steering lock bracket to the column tube, temporarily install the steering lock in alignment with the column boss.
- After checking that the lock works properly, tighten the special bolts until the head twists off.
- Cover the inside lip of the inner cover with grease and pull the outside of the cover onto the joint.
- Fill the inside of the bearing with multipurpose grease.
- Install the bearings to the shaft on the joint assembly.
CAUTION:
The steering lock bracket and bolts must be replaced with new ones when the steering lock is installed.