Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN
NOTE:
Make sure the battery voltage is between 10 and 16 volts before proceeding.
1. With the scan tool, read DTCs in all Electronic Control Units (ECU's) and record on the repair order.
2. With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Go To 3
CHECK FOR TRANSMISSION CONTROL MODULE (TCM) DTCS
1. With the scan tool, read Transmission Control Module (TCM) DTCs and record on the repair order.
  Are any TCM DTCs set?
  
  Yes
  - Repair TCM DTCs. Refer to: TRANSMISSION VERIFICATION TEST .
  - Perform the ESM VERIFICATION TEST. Refer to: ELECTRONIC SHIFT MODULE (ESM) VERIFICATION TEST .
  No
  - Using the schematics as a guide, check the Transmission Control Module (TCM) connector and all related in-line connector terminals for corrosion, damage, or pushed out terminals. Pay particular attention to the power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL AND INSTALLATION .
  - Perform the ESM VERIFICATION TEST. Refer to: ELECTRONIC SHIFT MODULE (ESM) VERIFICATION TEST .
CHECK WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle the wires while checking for shorted and open circuits.
4. Check for any Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ESM VERIFICATION TEST. Refer to: ELECTRONIC SHIFT MODULE (ESM) VERIFICATION TEST .
  No
  - Perform the ESM VERIFICATION TEST. Refer to: ELECTRONIC SHIFT MODULE (ESM) VERIFICATION TEST .
  - Test complete.