Diagnostic Test

CHECK FOR ANY SERVICE BULLETINS OR MODULE SOFTWARE UPDATES
1. Check for any applicable Service Bulletins or Flash updates related to the DTC.
  Are there any applicable Service Bulletins or Flash updates?
  
  Yes
  - Perform the applicable repair.
  - Perform the DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST. Refer to: DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST .
  No
  - Go To Next Step.
READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECU's) and record on the repair order.
2. For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To Next Step.
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION diagnostic procedure. Refer to: TESTING FOR AN INTERMITTENT CONDITION .
CHECK THE FRONT LONG RANGE CAMERA WIRING AND CONNECTIONS
1. Inspect the Front Long Range Camera wiring and connections at the camera and the DASM.
  Were any problems found?
  
  Yes
  - Repair as necessary.
    NOTE:
    Turn the ignition off for a minimum of 8 minutes allowing the vehicle to do a complete power down after repair(s) or connections. This will allow you to erase the DTC.
  - Perform the DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST. Refer to: DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST .
  No
  - Replace the Front Long Range Camera in accordance with the Service Information. .
  - Replace and program the Driver Assistance System Module (DASM) in accordance with the Service Information. Refer to: DRIVER ASSISTANCE SYSTEM MODULE (DASM), REMOVAL AND INSTALLATION .