Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN
1. With the scan tool, read ORC DTCs and record on the repair order.
2. With the scan tool, run a Vehicle Scan Report or record the Environmental Data.
3. With the scan tool, erase DTCs.
4. Turn the ignition off for at least 10.0 seconds.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read ORC DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to: RESTRAINTS SYSTEM INTERMITTENT TEST .
REPLACE THE OCCUPANT RESTRAINT CONTROLLER (ORC)
WARNING:
Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING:
If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.

When this code is set, view repair.

Repair
- Replace the ORC in accordance with the Service Information. Refer to: OCCUPANT RESTRAINT CONTROLLER (ORC), REMOVAL AND INSTALLATION .
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to: RESTRAINTS SYSTEM VERIFICATION TEST .