Diagnostic Test

CHECK FOR ANY SERVICE BULLETINS OR MODULE SOFTWARE UPDATES
1. Check for any applicable Service Bulletins or Flash updates related to the DTC.
  Are there any applicable Service Bulletins or Flash updates?
  
  Yes
  - Perform the applicable repair.
  - Perform the DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST. Refer to: DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST .
  No
  - Go To Next Step
READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECU's) and record on the repair order.
2. For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To Next Step.
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION diagnostic procedure. Refer to: TESTING FOR AN INTERMITTENT CONDITION .
CHECK FOR OTHER FRONT LONG RANGE CAMERA DTCS SET IN THIS MODULE
1. Refer to the saved DTC information recorded on the repair order.
  Were there any other Front Long Range Camera related DTCs set in this module?
  
  Yes
  - Perform the appropriate diagnostic procedure.
  No
  - Go To Next Step.
PERFORM THE FORWARD FACING CAMERA DYNAMIC SERVICE ALIGNMENT / CALIBRATION PROCEDURE - ERASE DTCS AND CHECK FOR DTC TO RETURN
NOTE:
Verify that the camera is securely mounted prior to performing the Forward Facing Camera dynamic service alignment / calibration procedure. A loose mirror mount can cause the Front camera to not calibrate.
1. Perform the Forward Facing Camera dynamic service alignment / calibration procedure in accordance with the Service Information.
2. With the scan tool, erase DTCs.
3. Turn the ignition off.
4. With the ignition off and the doors closed, wait a minimum of 90 seconds before checking for DTCs.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Replace the Front Long Range Camera in accordance with the Service Information.
  - Perform the DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST. Refer to: DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST .
  No
  - Performing the Forward Facing Camera dynamic service alignment / calibration procedure corrected the condition.
  - Perform the DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST. Refer to: DRIVER ASSISTANCE SYSTEM MODULE (DASM) VERIFICATION TEST .