Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECU's) and record on the repair order.
2. With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION diagnostic procedure. Refer to: TESTING FOR AN INTERMITTENT CONDITION .
PERFORM THE PROXI CONFIGURATION ROUTINE IN THE EAM
1. With the scan tool, perform the Proxi Configuration in the EAM.
2. With the scan tool, record and erase the EAM DTCs.
3. Cycle the ignition switch from on to off, wait five seconds and then back to on.
4. With the scan tool, read the active EAM DTCs.
  Is the DTC active?
  
  Yes
  - Replace the EAM in accordance with the Service Information. Refer to: MODULE, GLOBAL TELEMATICS BOX, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to: BODY VERIFICATION TEST .
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time.
  - Perform the BODY VERIFICATION TEST. Refer to: BODY VERIFICATION TEST .