LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2024 >> Compass Latitude >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) (2 Of 2) >> Module, Integrated Center Stack (ICSM) >> Removal And Installation >> Removal And Installation

Removal And Installation

REMOVAL 

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Using a trim tool or equivalent, remove the Integrated Center Stack (ICS) (1) from the instrument panel.
    GC0202771Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the ICS wire harness connector from the ICS (1).
  4. Remove the ICS (1) from the vehicle.

INSTALLATION 

  1. Position the ICS (1) to the instrument panel.
  2. Connect the wire harness connector to the ICS (1).
    GC0202771Courtesy of CHRYSLER GROUP, LLC
  3. Install the ICS (1) into the instrument panel, pressing firmly to verify the retaining clips are fully seated into the instrument panel.
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals