Diagnostic Test

POWERTRAIN VERIFICATION TEST 

1. Inspect the vehicle to make sure that all engine components are properly installed and connected. Reassemble and reconnect components as necessary.
2. After repairs are complete, erase all DTCs with the scan tool. Scan Tool Learn Procedures Component replaced or removed: Note: (All available Learn procedures should be performed when a PCM is replaced) Brake Pedal LearnBrake Pedal Position Sensor, Brake Pedal AssemblyCam Crank Relearn (NGC/GPEC Controllers)CKP Sensor, CMP Sensor, Flywheel, Vavletrain components (timing chain, gears, tensioners), Cam PhasersClear Misfire TLC (Magneti Marelli Controllers)CKP Sensor, CMP Sensor, Flywheel, Vavletrain components (timing chain, gears, tensioners), Cam PhasersClutch Pedal LearnClutch Pedal Position Sensor, Clutch Pedal, Clutch Assembly (pressure plate and disc)EGR Valve ReplacedEGR ValveLearn ETCThrottle BodyCheck PCM OdometerPCM ReplacedCheck PCM VINPCM ReplacedLearn Gear Shift SensorGear Shift Position Sensor, Transmission Shifter componentsFuel Adaptive Parameter ResetFuel Injector, High Pressure Fuel Pump, Fuel Rail, Fuel Pressure Sensor, Powertrain Control Module (PCM) GSE Injector AdaptationFuel Injector, High Pressure Fuel Pump, Fuel Rail, Fuel Pressure Sensor, Powertrain Control Module (PCM)
3. If the PCM has been replaced  , perform the Module Programming procedure. The PCM Reprogramming procedure is in PCM PROGRAMMING . Be certain to program the secret key code, VIN and odometer mileage after programming the PCM.
4. Operate the vehicle in accordance with the parameters and specific information found in the Monitoring Conditions and Theory of Operation of the DTC that was repaired.
5. With the scan tool, verify that no DTCs have returned.

   Are there any DTCs or driveability concerns present?

   Yes 

   • Check for any related Service Bulletins and/or and perform the appropriate diagnostic procedure. Refer to DIAGNOSTIC CODE INDEX .

   No 

   • Repair is complete.