Diagnostic Test

CHECK IF THE DTC IS ACTIVE 

1. Ignition on, engine not running.
2. With the scan tool, record and erase Memory Seat Module-Driver (MSMD) DTCs.
3. Cycle the ignition switch from off to on.
4. With the scan tool, read MSMD DTCs.

   Does the scan tool display this DTC as active?

   Yes 

   • Attempt to update (flash) the MSMD. If you are unable to update the controller, or if this DTC continues to reset after updating, replace and program the Memory Seat Module-Driver (MSMD) in accordance with the Service Information. Refer to MODULE, MEMORY SEAT (MSM), REMOVAL and MODULE, MEMORY SEAT (MSM), INSTALLATION .
   • Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST  .

   No 

   • Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .