Drivetrain Control Module (DTCM) - DTCS C2006-16 To C2206-64

• DTC Troubleshooting
  • C2006-16-Battery Voltage - Circuit Voltage Below Threshold
    • Notes
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2006-17-Battery Voltage - Circuit Voltage Above Threshold
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2010-16-Battery Voltage 2ND Threshold - Circuit Voltage Below Threshold
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2010-17-Battery Voltage 2ND Threshold - Circuit Voltage Above Threshold
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2020-01-Ecu Internal Fault - General Electrical Failure
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2020-47-Ecu Internal Fault - Watchdog-Safety UC Failure
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2020-48-Ecu Internal Fault - Supervision Software Failure
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2020-94-Ecu Internal Fault - Unexpected Operation
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2030-42-Ecu Software Failure - General Memory Failure
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2050-1C-Hall Sensors Supply - Circuit Voltage Out Of Range
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2060-09-Hall Sensor 1 - Component Failures
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2070-09-Hall Sensor 2 - Component Failures
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2080-09-Motor 1 Temperature Sensor - Component Failures
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2080-64-Motor 1 Temperature Sensor - Signal Plausibility Failure
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2090-09-Motor 2 Temperature Sensor - Component Failures
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2100-04-Motor 1 - System Internal Failures
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2100-13-Motor 1 - Circuit Open
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2100-14-Motor 1 - Circuit Short To Ground
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2100-15-Motor 1 - Circuit Short To Battery
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2120-04-Motor 2 - System Internal Failures
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2120-13-Motor 2 - Circuit Open
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2120-14-Motor 2 - Circuit Short To Ground
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2120-15-Motor 2 - Circuit Short To Battery
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2150-98-Motor 1 Power Stage Temp - Component Or System Over Temperature
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2160-04-Motor 1 Power Stage Test Failure - System Internal Failures
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2180-98-Motor 2 Power Stage Switch Temp - Component Or System Over Temperature
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2190-98-Motor 2 Power Stage Overload - Component Or System Over Temperature
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2200-04-Motor 2 Power Stage Test - System Internal Failures
    • Notes
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2201-64-OPERATIONALMODESTATUS Signal From Body Control Module - Signal Invalid
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C2202-64-Implausible Data Received From BCM Invalid Terrain Selector Status Can Signal Received From Body Control Module - Signal Plausibility Failure
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C2203-24-4WD Lock Switch - Signal Stuck High
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C2204-24-4WD Low Switch - Signal Stuck High
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C2205-24-Implausible Data Received From BCM Invalid External Temperature Can Signal Received Form Body Control Module - Signal Plausibility Failure
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test
  • C2206-64-Implausible Data Received From BSM Invalid Steering Angle Can Signal Received From Body Control Module - Signal Plausibility Failure
    • Notes
    • When Monitored And Set Conditions
    • Diagnostic Test