Folding Seat Module (FSM)

REMOVAL 

1. Disconnect and isolate the negative battery cable(s). Refer to 3.6L, BATTERY DISCONNECT AND CONNECT or 5.7L, BATTERY DISCONNECT AND CONNECT .
2. Remove the left rear quarter trim. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

   1 - Folding Seat Module Wire Harness Connectors

   2 - Locking Tabs

3. Disconnect the wire harness connectors to the Folding Seat Module (FSM).
4. Press the locking tabs while pulling out to remove the FSM.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

When the seat is replaced or the module is updated or replaced, perform the following calibration procedures using the scan tool: 

• Calibrate Full Recline
• Calibrate Stow
• Write Left Rear Seat Position
• Write Right Rear Seat Position