Removal And Installation: Removal

WARNING: This page is about a different car, the 2021 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
Remove the trim from the left inner quarter panel to access the Park Assist Module (PAM) behind the left rear wheel house. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Remove the two plastic push-pin retainers (2) that secure the PAM (1).
Disconnect the two or three wire harness connectors from the PAM connector receptacles.
Remove the PAM (1) from the vehicle.