LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2022 >> Compass Red >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Electronic Control Modules (Service Information)) >> Module, Instrument Panel Cluster (IPC) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2021 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

NOTE:

LHD shown, RHD similar.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the instrument cluster bezel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL AND INSTALLATION .
    GC0179083Courtesy of CHRYSLER GROUP, LLC
  3. Remove the four fasteners (1) that secure the Instrument Panel Cluster (IPC) (2) to the instrument panel.
  4. Disconnect the instrument panel wiring harness connector from the receptacle on the back of the IPC (2).
  5. Remove the IPC (2) from the instrument panel.
scientia non olet · About LEMON Manuals