LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System (Service Information) >> Generator >> Removal >> 6.2L Supercharged

6.2L Supercharged

WARNING:

Disconnect the negative cable from the battery before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage to the electrical system.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the air cleaner body. Refer to REMOVAL .
    GC0152294Courtesy of CHRYSLER GROUP, LLC
  3. Remove the serpentine belt (1). Refer to BELT, SERPENTINE, REMOVAL .
  4. Remove the Supercharger belt tensioner. Refer to TENSIONER, DRIVE BELT, REMOVAL .
    GC0152293Courtesy of CHRYSLER GROUP, LLC
  5. Unsnap the plastic insulator cap from the B+ output terminal.
  6. Remove the B+ terminal mounting nut at the rear of the generator. Disconnect the terminal from the generator.
  7. Disconnect the field wire connector (3) at the rear of the generator by pushing on the connector tab.
  8. Remove the one upper and lower rear generator mounting bolts (1).
    NOTE:

    It is not required to remove the bracket, loosen the bracket bolt, the generator will slide out.

  9. Remove the lower front stud nut bolt (2).
  10. Remove the generator from vehicle.
scientia non olet · About LEMON Manuals