LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Center, Power Distribution (PDC) >> Removal >> Removal - PDC Assembly

Removal - PDC Assembly

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0184436Courtesy of CHRYSLER GROUP, LLC
  2. Remove the Power Distribution Center (PDC) Assembly cover (1) from the PDC Assembly (2).
    GC0184488Courtesy of CHRYSLER GROUP, LLC
  3. Remove the PDC Assembly B(+) fastener and terminals (1) from the PDC Assembly (2).
    GC0184546Courtesy of CHRYSLER GROUP, LLC
  4. Release the retainers securing the PDC Assembly tray (1) to the PDC Assembly bracket (2).
    GC0184489Courtesy of CHRYSLER GROUP, LLC
  5. Carefully lift the PDC Assembly tray upward and disconnect the wiring harness connectors (1) from the PDC Assembly (2).
  6. Remove the PDC Assembly tray from the PDC Assembly bracket.
  7. If needed, remove the Powertrain Control Module (PCM) and bracket. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL .
    GC0184432Courtesy of CHRYSLER GROUP, LLC
  8. Remove the fasteners (1) and the PDC Assembly bracket (2) from the engine compartment.
scientia non olet · About LEMON Manuals