Motor, Window Regulator: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the door interior trim panel (2) For front Refer to PANEL, DOOR TRIM, REMOVAL
, or for rear Refer to PANEL, REAR DOOR TRIM, REMOVAL
.
- Disconnect the power window motor wiring harness connector from the motor electrical connector receptacle (3).
- Remove the fasteners (4) securing the power window motor and gear assembly (2) to the carrier plate (1) and remove the motor and gear assembly.