LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Grand Cherokee Trackhawk >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Electronic Control Modules (Service Information) >> Module, Keyless Ignition Node (Kin) >> Removal

Module, Keyless Ignition Node (Kin): Removal

  1. Disconnect and isolate the negative battery cable.
  2. Remove instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
    GC0173785Courtesy of CHRYSLER GROUP, LLC
  3. Using a trim stick, or a suitable wide flat-bladed tool, disengage the retainers securing the molded hard plastic outer edges of the steering column gap hider bezel (1) to the instrument panel.
    GC0173545Courtesy of CHRYSLER GROUP, LLC
  4. Position the steering column outward and slide the gap hider forward.
    GC0175275Courtesy of CHRYSLER GROUP, LLC
  5. Remove the fasteners (1) securing the bezel to the instrument panel and remove the bezel.
    GC0175213Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the Keyless Ignition Node (KIN) module wiring harness connector (1).
    GC0175250Courtesy of CHRYSLER GROUP, LLC
  7. Remove the fasteners (1) securing the KIN module to the bezel.
scientia non olet · About LEMON Manuals