Diagnostic Test

1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.

Did the DTC return?

Yes 

• Go To  2

No 

• Perform the appropriate INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .

1. With the scan tool, perform the proxi-alignment procedure.
2. Turn the ignition off, then back on.
3. With the scan tool, read DTCs.

   Is the DTC active?

   Yes 

   • Replace the Security Gateway Module (SGW) in accordance with the Service Information. Refer to MODULE, SECURITY GATEWAY (SGW), REMOVAL AND INSTALLATION .
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

   No 

   • The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .