Steering Column Shroud

REMOVAL 

1. Remove the steering wheel from the steering column. Refer to WHEEL, STEERING, REMOVAL AND INSTALLATION .
2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .

   Courtesy of CHRYSLER GROUP, LLC

   1 - Instrument Cluster Bezel

3. Remove the instrument cluster bezel.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Upper Steering Column Shroud

4. Use a suitable tool to disengage the gap hider from the upper steering column shroud.
5. Use a suitable tool to release the tabs and separate the upper shroud from the lower shroud.
6. If equipped with a steering wheel camera, lift the upper steering column shroud slightly.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Steering Column Shroud Screws

7. Remove the steering column shroud screws.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Steering Column Shroud Screws

8. Remove the steering column shroud screws.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Wire Harness Routing Clip

   2 - Wire Harness Routing Clip

9. Disengage the wire harness routing clips and remove the lower shroud.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Wire Harness Connector

   2 - Wire Harness Connector

10. If equipped with a steering wheel camera, disconnect the camera wire harness connectors and remove the upper shroud.
11. If equipped with a steering wheel camera, remove the camera from the upper shroud.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.