LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Gladiator Mojave, Part Time T/Case Control, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (8HP75 Automatic Transmission (Service Information)) >> Technical Specifications >> Torque Specifications >> Internal Transmission

Internal Transmission

WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS - INTERNAL TRANSMISSION

DESCRIPTION SPECIFICATION COMMENTS
Extension Housing to Transmission Bolt 27 N.m (20 Ft. Lbs.)  -
Hydraulic Impulse Solenoid (HIS) Bolts 27 N. m (20 Ft. Lbs.)  -
Output Speed Sensor Bolt 8 N.m (71 In. Lbs.)  -
Park Pawl Lock Rod Guide Plate Bolt 10 N.m (89 In. Lbs.)  -
Park Pawl Shaft Plug 35 N.m (26 Ft. Lbs.)  -
Transmission Oil Pan Bolt 10 N.m (89 In. Lbs.)  Tightening Sequence
GC0152239Courtesy of CHRYSLER GROUP, LLC
Transmission Oil Pan Drain Plug 9 N.m (80 In. Lbs.)  -
Transmission Oil fill Plug 35 N.m (26 Ft. Lbs.)  -
Transmission Oil Pump Assembly To Case Bolts Torque Procedure: 
  1. Firmly press the oil pump in place by hand before drawing it in with bolts. 
  2. In order to seat the oil pump cover properly, pre tighten bolts one, seven and nine to 6 N.m (53 in. lb.) 
  3. Tighten bolts to 10 N.m (89 in. lb.) starting at number one working clockwise 
  4. Rotate additional 90° in sequence starting at bolt 1 
 Tightening Sequence
GC0152246Courtesy of CHRYSLER GROUP, LLC
Transmission Oil Pump Housing To Cover Bolt Torque Procedure: 
  1. Tighten to 5 N.m (44 In. Lbs.) 
  2. Rotate additional 45° 
 -
Valve Body Bolt 8 N.m (71 In. Lbs.)  Tightening Sequence
GC0181792Courtesy of CHRYSLER GROUP, LLC
scientia non olet · About LEMON Manuals