Transmission Fill After Service

WARNING: This page is about a different variant/trim than selected.

CAUTION:

A unique transmission fluid has been developed for this transmission. This fluid is NOT compatible with ATF+4 or any other current FCA US LLC transmission fluid. For specifics about this unique fluid see FLUIDS, LUBRICANTS AND GENUINE PARTS.

To properly fill the transmission after an in vehicle service or overhaul, perform the following procedure:

NOTE:

If the transmission cooler was replaced, add an additional 0.7L (0.72 qts) of transmission fluid.

If the transmission was overhauled , prior to installing in the vehicle, tip the transmission on it side, remove the oil fill plug on the right rear side of the case and install 9L (9.5 qts) of transmission fluid. Install the fill plug. After installing the transmission, perform the CHECK FLUID LEVEL procedure. Refer to CHECK FLUID LEVEL .
If an in vehicle service was performed , raise and support the vehicle on a level hoist , and perform the CHECK FLUID LEVEL procedure. Refer to HOISTING, STANDARD PROCEDURE . Refer to CHECK FLUID LEVEL .