LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Gladiator Mojave, Part Time T/Case Control, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Steering System) >> Gear >> Removal And Installation >> AWD >> Installation

Removal And Installation: AWD: Installation

WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the heat shield to the vehicle.
    NOTE:

    The heat shield can only be installed to the engine compartment while the steering gear is removed.

  2. Position the steering gear in the vehicle.
    NOTE:

    A suitable strap may aid in holding the steering gear in position.

    GC0200273Courtesy of CHRYSLER GROUP, LLC
  3. Install the dash seal to steering gear fasteners (1) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
    NOTE:

    Apply medium strength threadlocker to the studs before installing the dash seal to steering gear fasteners (1).

    GC0200369Courtesy of CHRYSLER GROUP, LLC
  4. Install the bracket and tighten the bracket fasteners (1).
    GC0200329Courtesy of CHRYSLER GROUP, LLC
  5. Connect the Electric Power Steering (EPS) wire harness connectors (1, 2).
  6. Remove the strap and install both stabilizer bar links. Refer to LINK, STABILIZER BAR, REMOVAL AND INSTALLATION .
  7. Install the steering gear crossmember. Refer to CROSSMEMBER, STEERING GEAR, REMOVAL AND INSTALLATION .
    GC0200282Courtesy of CHRYSLER GROUP, LLC
  8. Install the steering gear bolts (1) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
    GC0200241Courtesy of CHRYSLER GROUP, LLC
  9. Remove the stand (1) from the front of the transmission (2).
    GC0200346Courtesy of CHRYSLER GROUP, LLC
  10. Position the heat shields to the steering gear then install the heat shield to steering gear fasteners (1, 2) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
  11. Connect the tie rods to the steering knuckles. Refer to TIE ROD, STEERING, REMOVAL AND INSTALLATION .
    GC0200370Courtesy of CHRYSLER GROUP, LLC
  12. Secure the exhaust hanger (1).
  13. Position the exhaust pipe to the resonator.
  14. Install the exhaust pipe clamp then tighten the cross-under pipe to exhaust pipe clamp (2) to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  15. Install the drive shaft. Refer to REMOVAL AND INSTALLATION .
  16. Install the belly pan. Refer to BELLY PAN, ENGINE, REMOVAL AND INSTALLATION .
  17. Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  18. Remove the support and lower the vehicle.
    GC0177266Courtesy of CHRYSLER GROUP, LLC
  19. Install a NEW  steering shaft to steering gear pinch fastener (1) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
  20. Install the dash seal to dash panel fasteners (2) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
    NOTE:

    Apply medium strength threadlocker to the dash seal to dash panel fasteners (2) before installation.

  21. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  22. Perform the Electric Power Steering (EPS) verification test. Refer to EPS VERIFICATION TEST .
  23. Perform the wheel alignment standard procedure. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals