Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN 

1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.

Did the DTC return?

Yes 

• Using the schematics as a guide, check the Electronic Shift Module (ESM) connector and all related in-line connector terminals for corrosion, damage, or pushed out terminals. Pay particular attention to all power and ground circuits. If no problems are found, replace the PRNDM.
• Perform the ESM VERIFICATION TEST. Refer to ELECTRONIC SHIFT MODULE (ESM) VERIFICATION TEST .

No 

• Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .