LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Gladiator Mojave, Part Time T/Case Control, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Power Liftgate (Service Information)) >> Chime >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the scuff plate from the liftgate opening sill. Refer to PLATE, SCUFF, LIFTGATE SILL, REMOVAL AND INSTALLATION .
    GC0177651Courtesy of CHRYSLER GROUP, LLC
  3. Move the quarter trim panel away from the lower right inner D-pillar far enough to access the power liftgate chime (1). Refer to PANEL, D-PILLAR TRIM, REMOVAL AND INSTALLATION .
  4. Disconnect the body wire harness connector from the chime pigtail wire connector.
  5. Disengage the retainer integral to the chime pigtail wire connector from the body sheet metal.
  6. Disengage the retainer integral to the chime housing from the body sheet metal.
  7. Remove the chime from the vehicle.
scientia non olet · About LEMON Manuals