Removal And Installation: Removal
WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
- Remove the driver air bag. Refer to AIR BAG, DRIVER, REMOVAL AND INSTALLATION
.
- From the back of the steering wheel, remove the left and right remote radio switch with paddle shift unit cover (1) from the switch by inserting a small flat screwdriver or equivalent into the slot and prying outward.
- Remove the switch retaining screw (1).
- Remove the switch from the steering wheel to gain access to and remove the steering wheel bezel retaining screw (1).
- Remove the upper switch retaining screw (1).
- Disconnect the electrical connector from the switch and remove the switch from the steering wheel.