Removal And Installation: Removal

WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

NOTE:

With paddle shift shown, without paddle shift similar.

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the driver air bag. Refer to AIR BAG, DRIVER, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
From the back of the steering wheel, remove the left and right remote radio switch with paddle shift unit cover (1) from the switch by inserting a small flat screwdriver or equivalent into the slot (2) and prying outward.

Courtesy of CHRYSLER GROUP, LLC
Remove the left and right switch (1) retaining screw (2).

Courtesy of CHRYSLER GROUP, LLC
Gently remove the left and right switch (1) from the steering wheel (3), to gain access to the steering wheel bezel retaining screw (2).
Remove the left and right steering wheel bezel retaining screw.

Courtesy of CHRYSLER GROUP, LLC
From the front of the steering wheel, remove the two retaining screws (2) that secure the steering wheel bezel.
Disconnect the Electronic Vehicle Information Center (EVIC) switch electrical connector (1).
Disconnect the speed control switch electrical connector (3) and remove the steering wheel bezel.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the left and or right wire harness connectors (1) and route the harness through the slots (2) within the steering wheel, removing the switch from the steering wheel.