LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Gladiator Mojave, Part Time T/Case Control, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Front Suspension & Wheel Alignment) >> Front >> Strut, Suspension, Assembly >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
GC0177687Courtesy of CHRYSLER GROUP, LLC
  1. Position the front strut assembly in the strut tower.
  2. Install the strut-to-strut tower mounting nuts and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  3. Install the cowl panel. Refer to COVER, COWL PANEL, REMOVAL AND INSTALLATION .
  4. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0177286Courtesy of CHRYSLER GROUP, LLC
  5. Install the front strut assembly to the knuckle.
  6. Install the strut-to-knuckle mounting bolts (1) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  7. Install the stabilizer bar link into the strut, and install the stabilizer bar link mounting nut (3) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  8. Install the brake hose bracket mounting bolt (2) to the strut and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
    GC0178207Courtesy of CHRYSLER GROUP, LLC
  9. Install the wheel speed sensor wire harness retainers (3) to the strut.
  10. Install the tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  11. Remove the support and lower the vehicle.
  12. Perform a wheel alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals