Diagnostic Test

WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. With the scan tool, erase all TBM2 DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read TBM2 DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the appropriate INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK THE (J240) ANTENNA CONNECTION
1. Turn the ignition off.
2. Disconnect the Antenna connector at the back of the TBM2.
3. Inspect the Antenna connections.
  Are the Antenna connections clean and secure?
  
  Yes
  - Go To 3
  No
  - Repair the Antenna connection as needed.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (J240) ANTENNA AND CABLE
1. Connect the 9977-6-CELL LTE test antenna (special tool #9977-6-CELL-LTE, Adapter, Cellular Antenna Diagnostic) to the antenna connection on the back of the TBM2.
2. Using the scan tool, erase the DTCs.
3. Turn the ignition on.
  Is the DTC active?
  
  Yes
  - Go To 5
  No
  - Go To 4
TEST THE (J240) ANTENNA CABLE
1. Disconnect the Antenna cable at the base.
2. Connect the appropriate special tool (#9977-6-1, Adapter) or special tool (#9977-6-3, Adapter) to the Antenna cable at the back of the TBM2.
3. Connect the appropriate special tool (#9977-6-4, Jumper) or special tool (#9977-6-2, Jumper) to the Antenna cable at the Antenna base.
4. Measure the Resistance across the tool terminals.
  Is the resistance above 30.0 Ohms?
  
  Yes
  - Use the special tool (#9977-6, Kit, Radio Antenna Diagnostic) to locate the open circuit, repair or replace the Antenna cable as necessary.
  - Once the repair is complete clear all DTCs.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Antenna base in accordance with the Service Information.
  - Once the repair is complete clear all DTCs.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
GLOBAL TELEMATICS BOX MODULE (TBM2)
1. Visually inspect the terminals on the TBM2.
2. Ensure the terminal is clean and free of any corrosion or damage.
  - Is the terminal free of corrosion and damage?
  Yes
  - Replace the TBM2 in accordance with the service information.
    Refer to MODULE, GLOBAL TELEMATICS BOX, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Repair the terminal as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .