Diagnostic Test

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
Did the DTC return?

Yes
- Go To 2
No
- Perform the appropriate INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
PERFORM A RESTORE VEHICLE CONFIGURATION
NOTE:
This DTC is not active while in "Winter" Mode.
1. With the scan tool, perform a restore vehicle configuration.
2. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
3. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Repeat this test.
  - Perform the TPM SENSOR VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Perform the TPM SENSOR VERIFICATION TEST. Refer to STANDARD PROCEDURE .