Diagnostic Test
- READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN NOTE:
To Press the ignition on the Passive Entry Keyless Go (PEKG)/Keyless Ignition Node (KIN) system, use the rounded end of the FOBIK to press the Stop/Start button.
- With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
- With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
- With the scan tool, erase all DTCs.
- Press the ignition off for a minimum of 10.0 seconds.
- Press the ignition on.
- Using the recorded Environmental Data and the When Monitored Conditions above, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the appropriate INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .
- EXAMINE THE KEYLESS IGNITION NODE (KIN)
- Check for anything that could cause the button to stick.
Could you find anything that would cause a sticking condition?
Yes
- Repair as necessary.
- Perform the RADIO FREQUENCY HUB (RF-HUB) VERIFICATION TEST. Refer to RADIO FREQUENCY (RF HUB) VERIFICATION TEST .
No
- Replace the Keyless Ignition Node (KIN) in accordance with the Service Information. Refer to MODULE, KEYLESS IGNITION NODE (KIN), REMOVAL AND INSTALLATION .
- Perform the RADIO FREQUENCY HUB (RF-HUB) VERIFICATION TEST. Refer to RADIO FREQUENCY (RF HUB) VERIFICATION TEST .
- Check for anything that could cause the button to stick.