Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. With the scan tool, record and erase the TBM2 DTCs.
4. Cycle the ignition switch from on to off, wait five seconds and then back to on.
5. With the scan tool, read the active TBM2 DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the appropriate INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
PERFORM THE PROXI CONFIGURATION ROUTINE IN THE TBM2
1. With the scan tool, perform the Proxi Configuration in the TBM2.
2. With the scan tool, record and erase the TBM2 DTCs.
3. Cycle the ignition switch from on to off, wait five seconds and then back to on.
4. With the scan tool, read the active TBM2 DTCs.
  Is the DTC active?
  
  Yes
  - Replace the TBM2 in accordance with the Service Information. Refer to MODULE, EMERGENCY ASSISTANCE (EAM), REMOVAL AND INSTALLATION or MODULE, GLOBAL TELEMATICS BOX, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .