Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read Memory Seat Module-Driver (MSMD) DTCs and record on the repair order.
2. Record the DTC Environmental Data.
3. With the scan tool, erase MSMD DTCs.
4. Turn the ignition off.
5. Turn the ignition on.
6. Move the Seat Switch in the horizontal position multiple times.
7. With the scan tool, read MSMD DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK THE (G401) DRIVER SEAT HORIZONTAL POSITION SENSE CIRCUIT
1. Turn the ignition off.
2. Disconnect the Driver Horizontal Seat Adjuster Motor harness connector.
3. Turn the ignition on.
4. Measure the voltage between ground and the (G401) Driver Seat Horizontal Position Sense circuit.
  Is the voltage above 11.0 volts?
  
  Yes
  - Go To 3
  No
  - Replace the Driver Horizontal Seat Adjuster Motor in accordance with the Service Information. Refer to MOTOR, SEAT, REMOVAL AND INSTALLATION .
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
CHECK THE (G401) DRIVER SEAT HORIZONTAL POSITION SENSE CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the MSMD C5 harness connector.
3. Turn the ignition on.
4. Measure the voltage of the (G401) Driver Seat Horizontal Position Sense circuit.
  Is there any voltage present?
  
  Yes
  - Repair the (G401) Driver Seat Horizontal Position Sense circuit for a short to voltage.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
  No
  - Go To 4
CHECK RELATED HARNESS CONNECTIONS
1. Turn the ignition off.
2. Disconnect all MSMD harness connectors.
3. Disconnect all related in-line harness connections (if equipped).
4. Disconnect the related component harness connectors.
5. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
  - Proper connector installation.
  - Damaged connector locks.
  - Corrosion.
  - Other signs of water intrusion.
  - Weather seal damage (if equipped).
  - Bent terminals.
  - Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
  - Terminals that have been pushed back into the connector cavity.
  - Perform a terminal drag test on each connector terminal to verify proper terminal tension.
  Repair any conditions that are found.
6. Reconnect all MSMD harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
7. Reconnect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
8. Reconnect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
9. With the scan tool, erase DTCs.
10. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
11. With the scan tool, read MSMD DTCs.
  Did the DTC return?
  
  Yes
  - Replace and program the Memory Seat Module-Driver (MSMD) in accordance with the Service Information. Refer to MODULE, MEMORY, SEAT (MSM), REMOVAL AND INSTALLATION .
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
  No
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
  - Test complete.