LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Compass Trailhawk >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Electronic Control Modules (Service Information) >> Module, Integrated Center Stack (ICSM) >> Removal And Installation >> Installation

Removal And Installation: Installation

GC0178868Courtesy of CHRYSLER GROUP, LLC
  1. Position the ICS (1) to the instrument panel and connect the wire harness connector to the ICS (1).
  2. Install the ICS (1) into the instrument panel. Be certain the ICS retaining tabs fully engage the instrument panel.
  3. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
    NOTE:

    If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

  4. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals