LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Compass Altitude, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Power Transfer Unit (Service Information)) >> Actuator, Shift >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the actuator on the PTU. Install and tighten the bolts to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
  2. Connect the actuator wire harness connector.
  3. Install the right front tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals