LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Compass Altitude, 4WD >> Repair and Diagnosis >> Electrical >> Starter >> Starting System (Service Information) >> Starter >> Removal And Installation >> Removal

Removal And Installation: Removal

NOTE:

Left Hand Drive (LHD) shown, Right Hand Drive (RHD) similar.

  1. Remove the battery and battery tray

    Refer to TRAY, BATTERY, REMOVAL AND INSTALLATION .

  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the belly pan. Refer to BELLY PAN, REMOVAL AND INSTALLATION .
  4. If equipped with Front Wheel Drive (FWD), remove the intermediate shaft. Refer to REMOVAL AND INSTALLATION or REMOVAL AND INSTALLATION .
  5. If equipped with All Wheel Drive (AWD), remove the Power Transfer Unit (PTU). Refer to REMOVAL AND INSTALLATION .
    GC0172700Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the wire harness connector (2) from the starter motor.
  7. Remove the B+ electrical connection nut (1) and disconnect the B+ electrical connection from the starter.
  8. Remove the lower starter bolt (3).
    GC0172633Courtesy of CHRYSLER GROUP, LLC
  9. Remove the upper starter bolt (1).
  10. Remove the gear selector cable retaining bracket bolt (2), then position the bracket (2) aside.
  11. Remove the starter motor.
scientia non olet · About LEMON Manuals