Removal And Installation: Installation
- Lubricate a NEW rubber grommet seal/filter screen with clean washer fluid and install it into the washer pump mounting hole in the washer reservoir. Always use a new rubber grommet seal/filter screen on the reservoir.
- Position the inlet nipple on the base of the washer pump unit (3) to the rubber grommet seal/filter screen in the reservoir.
- Using hand pressure, press firmly and evenly downward on the top of the washer pump unit (3) until the inlet nipple is fully seated in the rubber grommet seal/filter screen in the pump mounting hole of the reservoir.NOTE:
Be certain to connect the front and rear washer hoses to the proper outlet nipples of the washer pump. Failure to properly connect the hoses will cause the front and rear washer systems to operate incorrectly.
- Connect the front and rear washer hose fittings to the barbed outlet nipples of the washer pump. Be certain that the rear washer hose is connected to the black nipple and the front washer hose is connected to the white nipple.
- Connect the washer pump wiring harness connector.
- Install the left front wheelhouse shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Fill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.
- Verify the proper function of the front and rear washer nozzles.