LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Cherokee Trailhawk >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.2L Engine (Service Information) >> Engine Mounting >> Insulator, Engine Mount, Left >> Removal

Insulator, Engine Mount, Left: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the battery.
  3. Raise the vehicle.
  4. Remove the left front wheelhouse splash shield. Refer to REMOVAL .
    GC0183773Courtesy of CHRYSLER GROUP, LLC
  5. Remove the fastener (1) and remove the negative battery cable (2) from the transmission (3).
    CAUTION:

    Failure to remove the negative battery cable may overstress to the cable due to bending during service.

    GC0159327Courtesy of CHRYSLER GROUP, LLC
  6. Remove the belly pan (1).
  7. Lower the vehicle.
    GC0159652Courtesy of CHRYSLER GROUP, LLC
  8. Remove the PDC (1) assembly. Refer to CENTER, POWER DISTRIBUTION (PDC), REMOVAL .
  9. Carefully position a floor jack under transmission to support the transmission.
    GC0159450Courtesy of CHRYSLER GROUP, LLC
  10. Using care, remove the wiring harness loom (3) from the mount.
  11. Remove the transmission mount to frame bolts (2).
  12. Loosen the mount to strut tower bolt (4).
  13. Remove the bolts (1) at the transmission mount isolator to bracket.
    GC0159904Courtesy of CHRYSLER GROUP, LLC
  14. If required, remove the left side upper transmission mount bracket (1).
scientia non olet · About LEMON Manuals