Sensor, Intelligent Battery (IBS): Removal

WARNING:

Do not remove the captive nut, doing so will cause the stud to break.

Courtesy of CHRYSLER GROUP, LLC

Disconnect the two-pin Intelligent Battery Sensor (IBS) wire harness connector (1).
Remove the ground terminal M8 hex nut (2).

Courtesy of CHRYSLER GROUP, LLC
Position and secure the ground cable eyelet away from the battery terminal.
Loosen
the M6 (1) captive nut.

NOTE:
Do not remove the M6 captive nut, doing so will cause the M6 stud on IBS pole clamp to break.
Using the appropriate battery terminal puller, remove the battery cable terminal from the negative battery post.
NOTE:
Never pry the IBS to remove it from the pole clamp. This will damage the IBS and will need to be replaced.